BH6400D Chlorophyll Sensor for Water Quality Testing
Principle:
CS6400D Chlorophyll sensor uses the characteristic of chlorophyll A absorption and emission peaks in the spectrum to emit monochrome light of a specific wavelength into water. Chlorophyll A in water absorbs the energy of monochrome light and releases monochrome light of another wavelength. The light intensity emitted by chlorophyll A is proportional to the content of chlorophyll A in water.
Functions:
Based on the fluorescence of the pigments to measurement the target parameters , it can be identified before the impact of algal bloom.
No need for extraction or other treatment, rapid detection, to avoid the impact of shelving water samples;
Digital sensor, strong anti-interference ability, long transmission distance;
Standard digital signal output can be integrated and networked with other devices without controller.
Installation of sensors on site is convenient and fast, realizing plug and play.
Technical parameters:
Measurement range |
0-500 ug/L |
Measurement Accuracy |
The signal level of 1ppb rhodamine WT dye is ±5% of the corresponding value |
Pressure range |
≤0.4Mpa |
Calibration |
Deviation value calibration,slope Calibration |
Requirements |
The distribution of chlorophyll in water is very uneven, so multi-point monitoring is recommended. The turbidity of water is lower than 50NTU. |
Main material |
Body:SUS316L + PVC(fresh water),Titanium alloy(marine);O-ring:Fluorine Rubber; Cable:PVC |
Power supply |
DC:12VDC |
Storage temperature |
-15- 65ºC |
Measuring temperature |
0- 45ºC |
Dimension |
Sensor:Dia37mm*L 220mm |
Weight |
0.8KG |
Protective rate |
IP68/NEMA6P |
Cable length |
Standard:10m,the maximum may be extended to 100m. |